Access Control HP400ULPD4CB - Honeywell Power Products

Home > Products > Access Control Power Supplies

Access Control Power Supplies

HP400ULPD4CB

The HP400ULPD4CB is a 12VDC or 24VDC power supply with AC fail and Battery fail supervision, and a power distribution board that provides 4 power-limited PTC protected outputs. Each output has LED indication of PTC activation for diagnostic purposes. The unit has not been evaluated as elevator equipment, and is not authorized for bell output in Mercantile applications.

Data Sheet - (69 KB PDF)

Installation Instructions - (875 KB PDF)

Drawing - (193 KB DWG)

Enclosure Dimensions - (32 KB PDF)

	UL Listing ALVY.S6677 - Click Here
	UL Listing APHV.S6677 - Click Here
	UL Listing UTRZ.S6677 - Click Here
CSFM LISTING

Specifications - Power Supply Board
	Input voltage: 120VAC 60Hz; Current: 2.50A max.
	Output Voltage: 12VDC or 24VDC, jumper selectable; Current: 4.0A continuous output maximum, 3.5A plus battery charger (DC output not supervised).
	Fail safe dry contact output on AC Failure (within one minute).
	Built-in charger for sealed lead acid or gel cell type batteries.
	Instantaneous transfer to stand-by battery on AC failure.
	Battery presence detection (within 1 minute).
	Battery low disconnect at 9.90VDC or 19.90VDC.
	High voltage disconnect at 15VDC or 30VDC.
	Yellow LED (L3) indication for battery disconnected and battery low.
	Fail safe dry contact output for Battery trouble (Fail Safe).
	Battery polarity reversal protection.
	Thermal overload and short circuit protection.
	DC output PTC activated indication by Red LED (L2).
	DC output failure indication by Red LED ( L4 ).
	AC presence indication by Green LED ( L1 ).
	DC output indication by Red LED ( L5 ).
	Battery Leads included.
	Power Board Dimensions: 6.2”L x 4.7”W x 2.5”H.
	Enclosure Dimension: 17”L x 13.5”W x 4.75”H. Accommodates two 12 Volt 12AH batteries. When using larger batteries, a UL approved enclosure must be used.

Specifications - Distribution Board
	Power input may be either 12VDC or 24VDC.
	4 or 8 individually PTC Protected outputs rated 1.6A @ 23C with a maximum of 1.0A @ 49C (not supervised).
	Total current should not exceed the power supply rating used in the application.
	Green LED for input power indication.
	Red LED illuminates to indicate PTC activation.
	Board Dimensions 4 Output: 4.16 “L x 2.6”W x 0.8”H, 8 Output: 7.5 “L x 2.6”W x 0.8”H