| Home > Products > Access Control Power Supplies | |
Access Control Power Supplies |
|
|
|
HP600ULX
|
| Application Notice - This Application notice gives instruction to qualified personnel on how to configure the HP-UL series power supply to accept an AC line voltage of 230VAC at 50/60Hz. Be sure to measure ac mains output voltage before performing any conversions on power supply. |
||||||||||||||||||||||
Replacement Fuse Rating
|
||||||||||||||||||||||
| Specifications | |
 |
Input voltage: 120VAC 60Hz; Current: 2.50A max. |
|
Output Voltage: 12VDC or 24VDC, jumper selectable; Current: 6.0A continuous output maximum plus battery charger (not supervised). |
|
Fail safe dry contact output on AC Failure (within one minute) |
|
Built-in charger for sealed lead acid or gel cell type batteries. |
|
Instantaneous transfer to stand-by battery on AC failure. |
|
Battery presence detection (within 1 minute). |
|
Battery low disconnect at 9.90VDC or 19.90VDC. |
|
High voltage disconnect at 15VDC or 30VDC. |
|
Yellow LED (L3) indication for battery disconnected and battery low. |
|
Fail safe dry contact output for Battery trouble (Fail Safe). |
|
Battery polarity reversal protection. |
|
Thermal overload and short circuit protection. |
|
DC output PTC activated indication by Red LED (L2). |
|
DC output failure indication by Red LED ( L4 ). |
|
AC presence indication by Green LED ( L1 ). |
|
DC output indication by Red LED ( L5 ). |
|
Battery Leads included. |
|
Power Board Dimensions: 6.2”L x 4.7”W x 2.5”H. |
|
Enclosure Dimension: 17”L x 13.5”W x 4.75”H. Accommodates two 12 Volt 12AH batteries. When using larger batteries, a UL approved enclosure must be used. |
 |
|
|
|
|
|
|
|
|
HP600ULM |
|
HP600ULACM8 |
